Drive Unit For 240 Motor

A drive unit is a complete power source. Just fit a shaft, tube and a propeller that suits your model and fix into place in your craft. No need for universal couplings or difficult alignment. Cut a slot in the hull of your model and allowing enough clearance on the underside of the hull for the propeller glue into place. It is recommended that you use Loctite 609 to fix tube into unit and support arm

Drive Unit For 240 Motor

This 240 power source is a mighty midget. It will move a lot of water and will easily turn a 3 bladed 35mm diameter propeller. Using 6 volts with a 2 to 1 reduction the thrust from this small unit is amazing. Suitable shafts and tubes are part numbers B31D to B37D and suitable propellers are part numbers D21 to D23.